Getting To The Point – Options

Cost of Waterjet Cutting

You will realize that so many people have fallen for waterjet cutting. It is not uncommon for someone to pursue understanding the aspect of waterjet cutting cost. You will find it necessary to understand that so many different costs are attached to this waterjet cutting process. You will find that there are various consumables and power requirements that will have to be addressed. Water and abrasive will also come at a cost too. There are basically six different configurations known. They attract different costs. It is for this reason that it will be valuable for you to understand some of the costs attracted by this waterjet cutting. They will often comprise of the following.

There is a cost attached to water. It is necessary to indicate that this will often be the most affordable of all expenses. This water is relied on for cutting as well as cooling. You will find that 3.5 dollars will every so often be used on a 1000 gallon. You will realize that you will have to spend about 1200 to 2500 dollars every year. It is imperative to mention that there will be a need for you to pay an extra amount for the sewer as well. This will in most cases be determined by the location. There are given regions that will cost a higher amount as compared to others. It is necessary to indicate that the intensifier pump will also have to be run. This will often depend on power. Igt is certain that you will have to spend an amount that ranges between 3700 and 9400 on a yearly basis for power. This will depend on your usage. These figures are pegged on the use of pumps of between 50 and 125HP.

Abrasive comes at a cost too. It will definitely cost more than all the others. It is important to state that there are often two main garnets that you will find at your disposal. We often have the hard rock and the alluvial garnets. You will find that hard rock will often be sharper. This is what will make it tend to cut faster. The alluvial garnet will often come with rounded grains. This implies that you will be required to pay more for the hard rock. There is also a need for you to consider the cost attached to the abrasive flow rate. It will every so often call for you to spend about 26000 to 55000 dollars each year.

It will also be necessary for you to take into account the cost of wear and tear. Replacement of certain parts such as orifice will be quite common. There are miscellaneous costs on the pump parts too. You can spend on them up to 32000 dollars each year.

Finding Ways To Keep Up With Machines

Questions About Equipment You Must Know the Answers To